Getting Your PCB Lines Right with Gallium Iodide Lamps If you’re running a PCB shop, you know the headache of over-exposed photoresist. It...

Stop Replacing Your UV Lamps Every Few Months Let’s be honest: nobody likes the cycle of replacing UV lamps. It’s a pain, it’s expensive, and dealing...

Getting Your UV Curing Right: A Look at Gallium Iodide We spent some time at the 2026 Printing Exhibition showing off our custom Gallium Iodide (GaI)...

Getting Your UV Spectrum Exactly Right: Custom Gallium Iodide Lamps Standard mercury vapor lamps are fine for some things, but they aren’t a...

Fixing the “Wet Bottom” Problem in Industrial Printing We spent some time visiting about 3,000 printing plants, and we kept seeing the...

Introduction If you’re running a flexo label press, you know the UV curing station is where things can fall apart. Standard lamps just...

Out on the floor, a job only counts when the press is running and the cure is holding steady. If the lamp starts slipping, you know it right...

On the garment line, flash-drying inks usually comes with a side of VOCs—smell, irritation, and post-cure headaches. The real culprit is incomplete...

Introduction We built this 3000W, 380V gallium iodide lamp for the places where heat and UV need to be rock-solid, day after day. Think industrial...